Our belt shields can be painted in groups colours, insignia or heraldry to show the membership to a certain group. Made from 1,2 mm steel, we offer them in our favorite plate armour series now. This belt shield was, just like the entire "Lucas" series, built with a corrugation along the edge. It is worn on the belt, which is pulled through the two leather belt loops on the top. Naturally it can be worn as a small tasset on the thigh. The belt shields are, just like our arm shields, ideal to be painted, modded and combined with existing costume parts. This is, where your creativity and immagination comes into place. Talking of creativity: We suggest to clean the shield with Acetone prior to üainting it. Afterwards just sand it with a paper with 600 grid. Use some automobile colour primer as the colour-matching foundation. When the foundation is fully dried, you should sand it again and apply a second layer of colour. Now is the time, where you can paint your details, like heraldry, animals and writings with weatherproof acrylic paint. Material: 1,2 mm steel Length: 24 cm Width: 18 cm Weight: app. 350 g Our products are handcrafted, so dimensions and colour tones may vary slightly. Photographic images and screen settings may not accurately represent colour tones.

Our "Lena" armour series was especially designed for warrior princesses and shield maidens alike. We distanced from historical patterns and steped closer to a rather fantastic shape. The outcome was a not only a long awaited womens armour, but also a costume set of in the form of a worthy armour set. Be it an Amazone, a warrior princess or an exalted priestess - all of them are possible by combining the armour with the right clothing pieces...Only your imagination limits the possibilities. For all you ladies out there: this is the right armour, not only on LARP events.The "Lena" neck choker is armour and accessory at the same time. It finishes off the "Lena" armour to the top and enlongens the wearers neck. This way the female warrior appears longer and the elfen princess even more raised. The buckle on the backside and a slight, carefull bending allow the chocker to be adjusted even to larger necks by the wearer individually. The chocker is being worn on top of the gorget and does not need any additional attachment. The choker can be worn without any armour as a piece of jewllery; this makes this plate armour piece something special for the women.As always: all edges and points are beaded for additional protection.Material: 1.2mm steelNecks circumference: app. 30cm (+ leather strap)Length: 11cmWeight: app. 200gr

Our "Lena" armour series was especially designed for warrior princesses and shield maidens alike. We distanced from historical patterns and steped closer to a rather fantastic shape. The outcome was a not only a long awaited womens armour, but also a costume set of in the form of a worthy armour set. Be it an Amazone, a warrior princess or an exalted priestess - all of them are possible by combining the armour with the right clothing pieces...Only your imagination limits the possibilities. For all you ladies out there: this is the right armour, not only on LARP events.The "Lena" series gorget appears smaller and more delicate than most other plate metal gorgets. despite of this, it works just as good as a plate spaulder carrier with the two buckle/straps on the sides. It is being closed with a simple strap and can be closed by the wearer when fully armed.You can wear all our spaulders from all series in combination with this gorget.Younger heroes, kids and smaller persons can wear this gorget in a combination with the small spaulders from the "Adam", "Balthasar" and "Markward" series.If your costume creation allows a padded gorget - we suggest to wear padding underneath all metal armour pieces, as this prevents bruises and scratches when being armed.Material: 1,2mm steelNeck circumference: app. 44cmLength of the front segment: 10cmLength of the back segment: 10cmWidth: 27cmWeight: app. 600gr